In that case, if the glass was kept in the cold before cutting, enter it in a warm room, so that it has been heated.
Prepared the way described above, place the glass on a flat and smooth surface, after which the marker Draw those lines, which need to be held glass cutter. In this line check so that the edge of the glass blocked folds to 3 / 4 of their height. Glass take such a thickness that between him and the rebate has remained at the interval 0,2 see Adhering to these levels, you can easily insert the glass into place and to avoid damage due to swelling of wood from moisture.
Cut glass should be strictly in line or rail. Instead of slats can also use insulation tape. Cut start from the far edges of the canvas. Spend on a glass surface - for yourself - only once, pressing evenly on the glass.
In the process of cutting glass must publish a faint crackling sound when the correct operation of a good glass cutter on it should remain barely perceptible trace colorless. Before we break off the glass, under him at both ends to put a match - this slightly rear its sheet glass and provide an even break. Then arrange it so that the cutting line is accounted for on the edge of the table, and faults his hands.
If the edge of the narrow window, then break off their slits hammer or a glass sponges pliers, which are wearing rubber caps. In that case, if the glass is incised enough, turn it back side and a hammer tap the entire length of incision.
When working with glass cutter carbide crush on him a little more than a diamond glass cutter. If the incision does not work, then the roller tool should hold for some time in kerosene, and then repeat the cut. If the incision does not get this time, then turn the glass and make an incision on the back side. If you need to cut the glass a certain form, then put it under him a pattern to follow and cut.
When you're wired glass cuts, the first of its smooth surface make a cut glass cutter, then any sharp instrument along the entire incision to do the deepening of the grid, then turn the glass and fractures. Wire neatly cut.
Wednesday, October 14, 2009
Tips for Cutting Glass
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment