Tips on drawing texture coating on the walls of the kitchen

Texture coatings and decorative effects in the design of the walls due to modern technology and a large selection of new high-quality materials readily available, and virtually anyone can use them to repair their apartments. They are easy to conceal small cracks and defects. Applying different texture coating, you can create in their house special, cozy atmosphere. Decorative texture coatings are easy to use with them fairly quickly mastered by even an inexperienced artist, while he has space for creativity.

Under the textured coating is commonly understood as the usual decorative plaster, but with the inclusion of mineral (texture), a binder and color fillers. Decorative and texture they are called because they have color and form on the surface of special relief, texture, and, moreover, does not require additional finishing. Such coatings can be applied to the base of concrete, bricks, drywall, ceramic tile, metal, wood and other materials.

If your kitchen is connected with the dining room, you can select a zone of cooking: the surface of a desk, sink and appliances make a smooth and easily washable, and the remaining space of chains with textured coating.

For that you will need the following tools: a spatula, a fur roller, brush-fleyts, tape measure, level, string, a long ruler, pencil, steel and plastic float, painting paper tape, sandpaper, stepladder, a bucket of water. Depending on the types of coverage apply them to the wall using different tools. Using a steel trowel, you can get a flat surface with the texture determined by the size of the color granules. Plastic is convenient to create a smoother textured surface, roll - relief and wavy, and spray - reliefs type coat. The surface on which you apply the invoice covering should be dry, clean and smooth as possible and not crumbling. All that has a water-repellent qualities or is unable to hold the weight of the deposited coating (dirt, dust, grease, oil, moisture or mildew stains, etc.), remove the wire brush or sandpaper. If the surface of the metal, then clean it of rust and double cover of the alkyd paint colors.

Large defects and shtraby Wired zashpaklyuyte, then apply primer to the surface of acrylic in the tone of coverage. This is all the more necessary if the authority is able to rapidly absorb water (gypsum, macroporous and old, crumbling plaster). Seams at the juncture of panels and the corners proshpaklyuyte, dry, and cursed building with a bandage with PVA glue.

The day after puttying in two coats and sanding with sandpaper then wipe the walls with a dry cloth, and then define the upper limit of coverage (for 1-1,5 cm below the ceiling) and her painter's stick tape. Then fur roller evenly in one layer on the whole area of work, apply a primer.

After the primer dries, apply a 1,5-2 hours prior to the surface coating of the desired tone.

After 3-4 hours, when the preliminary coating dries, it is possible to apply the basic material. Postpaid coverage pasty consistency, apply with a steel float movements of bottom-up approach, starting from the top of the wall, and Boost Cross-motion across the entire width.

Apply cover better from corner to corner. If the surface is large, it can be divided into sections of 5 m 2 with mounting tape. When alignment strongly push for smoother, holding it at a slight angle to the surface of the wall.

After 20-30 minutes, when the treated areas the material will dry out, start to wipe his flat plastic trowel alternating circular and straight movements. If you watch carefully, that the working surface of the tool was not dry, and if necessary, moisten it with water.

Launched plot should always touch up completely on the same day. If for any reason you had to interrupt work, then the edge of the treated area Protect from drying mounting tape. Within 5-6 hours after the end of the wall ready.